Discussion Locked

Does not recognize dimm

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a system which uses the VX-PRO II chipset. When attempting to add more ram (168 pim Dimms) the system will not recognize it, it only locates the 16Mb on board ram. Is there any way to get the system to recognize this new Dimm?

5 replies

by Former member

Found this from Intel>

Hello,

Do you know what technology (16 or 64 Megabit) the DIMM is or if it is double sided or not? The 430VX only supports 16Megabit technology. Do you know the width of the memory components on the DIMM? The 430VX does not support SDRAM x4 devices (SDRAM Width). Please see the following web site for more information on this issue:
http://support.intel.com/support/chipsets/430vx/KBATDN7V.HTM.

The maximum memory supported by the 430VX on one DIMM is 32MB. This configuration comprises of a double sided DIMM, 4Mx64 with SDRAM Width of 8 using 16Mbit technology. The 32MB configuration of a single sided DIMM, 4Mx64 with SDRAM Width of 4 is not supported.

For more specific information regarding the 430VXchip set please see the Intel(R) 430VX PCIset - 82437VX System Controller (TVX) and 82438VX Data Path Unit (TDX) datasheet at:

ftp://download.intel.com/design/pcisets/datashts/290553.htm.

Please make sure that your motherboard supports mixing DIMM and SIMM memory modules. The following statement is taken from section 4.3.1 of the 430TX datasheet (ftp://download.intel.com/design/pcisets/datashts/290559.htm):

?It is not recommended to mix SDRAM (which are 3V devices) with 5V EDO/FPM SIMMs, unless the SDRAM and EDO/FPM are properly isolated (e.g., isolate the memory data lines with Qswitches). Mixing 5V and 3V memory is not recommended for reliability reasons. Not all SDRAMs are 5V tolerant.?

The 430VX datasheet does not have this same note. Instead, it states that it is okay to mix SDRAM and EDO/SPM memory for designs with 4 rows of memory but not for 5 rows of memory. The excerpts below are taken from Section 4.4.1. DRAM Organization of the 430VX datasheet.

?(for 4 rows) SDRAMs can be mixed with EDO/SPM on a row per row basis (e.g., row 0 can be populated with SDRAMs while row 3 can be populated with EDO/SPM). TVX runs with optimized timings on

by thechas

Many of the older chip sets and BIOSs are very picky when you add more memory.

I have an older mb that accepts a maximum DIMM size of 32MB. And then only double-sided PC66 DIMMs at that.

Try and identify the MB mfg, and see if they have either an FAQ on compatable DIMMS, or a BIOS update to allow the MB to handle newer larger DIMMs.
You can use the BIOS string that is near the bottom of the screen during the memory test at either www.motherboard.org
or www.wimsbios.com
They can link you to the mb mfg web site.

Some of these older boards had some rather strange memory limitations.
Some required EDO DIMMs for maximum supported memory.
Many support double the memory in the SIMM banks than they do in the DIMM banks.

Blame this on the ongoing evolution of the PC. They just didn't have the DIMM specification fully defined when these boards were designed in the mid 90's.

Chas

This discussion is closed to new replies.