Discussion Locked

drive's detecting

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

dear sir!
i have a GFXcel board and one ASUS cd drive and one Seagate 20GB hard disk.my problem is that some times cd ROM not detected everything is ok like cable,jumpers etc,i did made cd drive master or slave but cd not detecting in secondry master or primary slave .but when i make a single master drive without HDD cd ROM detect.
sir is it a error of power supply or bios?
plz solve this problem with your experience
THANK YOU

8 replies

by mikex

How many Wats is your current Power supply ?

Other decisions - try with a different combinations :

1. Attach Hdd as a Primary Master Single on IDE 1

2. Attach CDROM as master on the second IDE channel - then if it's not working properly - try a CABLE select jumper settings if it's not working again try to update your BIOS

by mikex

It's impossible for the Power supply to be a 12W, you've must reading something wrong however if it's realy 120W which is unusual change it at least for a 250W 230V - Don't forget to check the OUTPUT for ATX Motherboards

by electricdragon

You could try going into your bios and doing an "Autodetect hard drives"
Also, if your pwr supply is only 120 watts you may be using a "Y" connector to power the CD, if so, try pairing it with the floppy, and not the HD.
HTH,
E.D.

This discussion is closed to new replies.