Discussion Locked

Erratic display of time on systray and D

0 helpful
13 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a peculiar problem. Since last few days, my clock display on the system task bar shows a different time than on the Date/Time Properties box when I try to adjust the time. The difference is always 30 min and the display in the control box keeps changing. It will move forward to match the task bar display then set itself again with 30 mins plus.

13 replies

by steve cody

From your domain, I can see that you must be in India. Check your Time Zone settings. When you go into the Date/Time properties, see if you are set to a zone in India. It may be a quirk of being in your time zone that the clocks are not syncronized. This is because your time is 1/2 hour off plus the normal time difference from time zones in the U.S.
This is just a guess, but it's probably a bug in the way Windows handles time zones that are "non-standard".

-Steve

by renewlife

Hi, I have for the past few months had a problem with my time display. My computer actually appears to be losing time. I reset, checked the time zone, and even went into the CMOS setting where the time appeared correctly. In the meantime my computer slowed way down (Gateway 2000 266), and I was getting very frustrated. I operate on Windows 98. When I reset the time it works fine for a short period and then bingo I am losing time again.

I may have solved my problem by going into my computer, control panel, and regional settings and changing the short date to mm/dd/yyyy. I also went to Microsoft and updated the Y2K downloads. It appears to be working correctly the past twenty four hours. Oh yes i also hit refresh on the devices for everything pertaining to time.

This may or may not help, but may be worth a try if you operate on windows 95/98.

Sincerely,
Jim Shelar

by dmiles

This could be caused by a bad battery or a overheating problem,check the settings in the CMOS to see if they are set to default and the correct region settings.

by fumitake

The only thing that I could add is that maybe you have the system accessing an atomic time syncronization that is set to an incorrect time zone.

by thedrummer2006

Your Mother boards backup battery might be going dead. This keeps your bios chip supplied with power. If this battery goes dead your Bios will not retain memory, however this also means that it will forget what type of hard disk drives, and floppy drives you have and the next time you shut down and reboot it will not boot up. If it does not have a problem rebooting then you have a software problem.(windows)

by chrisfraser

If you log onto a network, the server may be setting your time. In that case, the clock on the server may need to be corrected.

This discussion is closed to new replies.