Discussion Locked

Errors at startup

0 helpful
14 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
At start of boot-up, Compaq PIII shows error messages, then you can press F1 to boot to windows 98. Messages are: 611-primary foppy port address assignment conflict, 162-System Options not set, 601- Diskette controller error. I recently upgraded from W95 to 98. Where do I go in setup to correct this? Device manager shows sound card problems only.

14 replies

by pierrejamme

Compaq usually uses F10 to get into the BIOS and there you can select the "Default Setting" or something similar. Also make sure the floppy is the correct king, ie. 3 1/2" 1.44 MB or whatever it is.

by randerson7

I have tried to reset the defaults and the floppy is not recognized in cmos. I tell it that it is there as 1.44 MB, but it does not retain this setting.

by oz_media

If you have an aftermarket graphics card (most Compaq's come with on board graphics chipsets and an NVIDIA AGP card), just pull the AGP card connect the monitor to the onboard connection and try booting, from there you can use the device manager to reinstall you graphics card.

If not, you MAY be able to get into safe mode by pressing F8 releatedly during initial post, once in SAFE mode, remove and reinstall the graphics card/drivers.

by oz_media

Correction: Same as above but with the sound card.

Compaq geberally uses AC97 or SoundMax onboadr chipsets. if you have installed a separate sound card, the first MUST be disabled or the new card will seek new interrupts.

by bbbucko

When you say you upgraded to 98, did you do that from within 95 or did you fdisk and format your drive and then load 98?

The error msgs you are getting have nothing to do with Windows, they are coming from the BIOS.
Did you accidently delete the non-dos system partition that contains all the info Compaq's need to boot? sounds like it! No biggie - download the latest system disk from the compaq support site. What model compaq have you got? I can point you in the right direction

NOTE: your sound card issue in device mgr should be fixable with a the latest chipset/sound card drivers from the compaq support site

by bbbucko

hmmm - could be a flat CMOS battery then but you'd probably be getting another POST error telling you to set the date and time.

Have you tried clearing the CMOS? - just about every Compaq allows you to do this with a mobo jumper.

Do you still get the POST errors without the soundcard inserted?

What model compaq is it? Might be worth checking for an updated BIOS

by randerson7

I used current HDD and formatted, did not fdisk or change config. Sound card is PCI, not onboard.

by stress junkie

I've been buying and building pcs for a long time. I've
found that branded pcs are often built for one
particular operating system. Case in point, I 'recently'
bought a Compaq pc at a normal retailer. The Compaq
had Windows XP preinstalled but I wanted to run
Windows 2000 personal. Windows 2000 just wouldn't
work. Period. I restored the XP system from CD-ROM
and the machine was ok. Apparently this Compaq
machine will only work with the Compaq distribution of
Windows XP.

FYI building from scratch is often worse. You often
purchase the various parts only to find that this or that
just plain won't work. You can easily end up buying
two or three video cards, or whatever, to find one that
finally works.

This discussion is closed to new replies.