Discussion Locked

Floppy drive I/O error

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
A floppy drive on a PC shows busy and reads the disc but then reports "A:\ is not accessable. The request could not be performed because of an I/O device error.

7 replies

by bfilmfan

Check and make sure the floppy drive controller cable is seated properly.

If it is, you have either a bad cable or drive.

by gary56789

Yes, check for bad floppy drive/cable first. If OK, make sure it is set to "read-write" access in BIOS. If it is, uninstall floppy driver, reboot.

If still not OK and you have XP SP1, post a comment and I will send you the link

by dmiles

Be sure the Standard BIOS Setup is set correctly for your floppy drive (most are 3 1/2 inch, 1.44 MB). If you have more than one floppy drive, check to see if you have Floppy Drive swapping Enabled in CMOS. Are the floppies write protected; i.e., when looking at the back of the floppy with the metal door down, the little tab in the rectangular hole at the top, left of the floppy blocks light. In the Windows Explorer, right-click the floppy drive and format the floppy with the transfer system files option selected. Try another floppy drive. Replace the floppy cable. Sometimes they get nicked. If the floppy drive LED stays on all of the time, you have the flat cable plugged in backwards on either the motherboard or drive; the red stripe goes to pin 1. You could have a bad box of floppies. Try one of the suspect floppies in another computer after running a virus scan on them.
Throw away that magnetic screwdriver.
Clear out My Documents

by cg it

if the light on the floppy drive is on all the time pin 1 on cable isn't matched with pin 1 on the floppy drive.

by stavangerboss

The light is staying on probably due to a reversed cable, thus giving the impression of reading the disk.

Could also be a bad drive.

by stavangerboss

The light is staying on probably due to a reversed cable, thus giving the impression of reading the disk.

Could also be a bad drive.

by sgt_shultz

i have rubbed my magnetic screwdriver all over my floppy disks and it doesn't hurt them a bit. that is an old wives tale, imho.

This discussion is closed to new replies.