Discussion Locked

Freezes/Hangs/Crashes in 3D Games

0 helpful
27 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

My computer will freeze (usually with an annoying constant beep) after playing any new 3D game for a few minutes.

I have updated all drivers. I have updated my BIOS. I have made sure that there is no IRQ conflict with the video card.

I have run MemTest86 several times. The first time it came up with 4 errors. However, I have run it several times since with no errors. I have also run DocMemory without finding any errors.

I have run several "Burn-in" and Benchmark programs. None have crashed the computer.

My computer has the following hardware:

Intel Pentium IV 2.4 Ghz 533Mhz
Radeon All in Wonder 7500 64MB
80 GB 7200RPM Hard Drive
1.44 Floppy Drive
Enermax CSX305 Wind, Neon, 350
WindowsXP Pro OEM
512MB PC3200 400Mhz DDR-RAM
ECS L4S8A2 SIS 648 Motherboard
SoundBlaster Live! MP3+
SAMSUNG SV2001H (20GB Hard Drive)
LG CD-RW CED-8080B Sony DVD-ROM DDU1621

I have tried all of the possible BIOS changes that ATI suggested. Most were not available in my BIOS, but theones I could change didn't work.

I did notice at first that my on-board USB controller was in conflict with my video card (showed both using IRQ 11 when booting comp). However, even after disabling the USB controller in the BIOS, I still had the same problem.

So what is the problem? Please help me!!

27 replies

by cg it

First, what size power supply do you have? If it's 300 watts, I would tend to think that it's just not enough with all that your running.

Second is the ATI card. Their drivers [and driver support {except on the their new 9800 card} is dismal at best.

Third is Windows XP...have you installed the latest updates and patches?

Also note: devices that are assigned the same IRQ that you see in the BIOS are not necessarily in conflict with one another. Devices do share IRQ's [unlike back in the days of DOS/Windows 3.11 where devices could not share IRQ's].

Still, I would venture to day that your problem is mostly likely with Windows XP and your Radeon card/drivers. [Even PC Gamer Magazine gives Radeon drivers and support a thumbs down].

by justme2007

My Power Supply is 350W. So unless that is also too small, that isn't it.

I have downloaded all of the newest updates for windows.

So does this simply mean that my video card is uncompatable with windows XP? It claims to be compatable.

My question is, what can I do to fix this?

(and as a side question, If it is impossible, how do go about proving this to the store I bought it from, cuz I'm too poor to be paying for an extra video card!)

thx for the post.

Ps. I was aware about the IRQ thing. However, a conflict in IRQs was what the people I bought the system from claim was the problem. They were wrong, but I mentioned it here just in case someone else was going to suggest the same thing.

by dmiles

After trying answer 1,you are still expierencing problems then you may have an overgeating problem

Do you have adequate ventilation and cooling setup in the system,you will need more than one fan to provide cooling for the cpu which seems to be running hot after playing games for a certain amount of time,check the heating of cpu,using the system heating monitors,download the latest Direct X,I have read mention that DDR could cause this to happen also,insure memory is seated properly and you are not using mixed modules

by justme2007

I have installed a program for monitering temperature. It has NEVER exceeded 50C. It usually runs at about 30-32C. It has frozen at less than 36C.
And I have only one memory module. It is seated properly.

by dmiles

Check for CPU over heating,most newewr systems have a over heating monitor in the BIOS setup

Also check the memory modules to insure tthey are seated propely and you donot have mixed modules

Check the beep code,you may find answer there.

by justme2007

I have installed a program for monitering temperature. It has NEVER exceeded 50C. It usually runs at about 30-32C. It has frozen at less than 36C.
And I have only one memory module. It is seated properly.

by cg it

Ok, well.....next to try is disabling sound in the game that causes your problem. Then run the game and see if it freezes. Do you have all the "bloatware" software that came with the Soundblaster live installed? or just the sound drivers?

A cause of game freeze or crash to the desktop can be the sound card. If after disabling sound and the game runs fine, download the latest drivers from Creative, also get any patches or fixes for the game your trying to play.

by cg it

I'll direct you to a gaming site where I know many of the gamers there use ATI Radeon cards. They have a community forum section on different games and a help me forum for issues with games.

This is Dasmerg.net Gaming Community. On the left hand pane you'll see main menu and site navigation. Under site navigation is community forums. Click the link to go to their forum section. Under the Wassabi section, you'll see help me! Post a question there for the particular game your playing and giveyour system info. Someone there will probably know an answer as they probably have played that game or know someone who did/does and have an answer.

http://www.dasmerg.net/pn_7/html/index.php

by justme2007

I tried disabling the sound in the game. This didn't work. I tride disabling the on-board soundcard. This Didn't work. I tried disabling the SoundBlaster. One game I tried didn't crash, but the others did. And the one that didn't crash may not have had an adequate test to find out if the problem is actually fixed with that game. (And no sound wouldn't actually be fixing it anyway.)

I have already downloaded the latest drivers/patches from Creative.

by ann777

1)
Which version of DirectX are you using? 9.0 Full is available now... (MS has patched all the reported bugs in the beta version and made it downloadable).

http://www.microsoft.com/windows/directx/default.asp

Please remove any embedded spaces from the above link when pasting into your browser.

That's really all I can suggest from what you've posted.

by dcosgrove

The annoying beeps usually indicate a thermal condition being monitored in the bios. As you are monitoring your temp from some source outside the bios, I would suspect 2 things. A misreporting sensor would be the first. Is there a thermal protection entry in your bios? If so, try disabling it. Are there fan monitors in your bios, if so, try to disable any system halts or send errors associated with this. Second would be that your add on monitoring software is using a different sensor thanthe bios or requires an additional sensor which may not be present. One additional thing to improve 3dgame performance is to empty c:\windows\temp folder, some games won't run at all if it's over stuffed.

by justme2007

Emptying windows Temp didn't work.

The program I am using (HMonitor, http://www.hmonitor.com/) lists my mobo as compatible with the software. I even ran a "test". I compared what the BIOS said the temp was with what HMonitor said the temp was. They were only 2 degrees off. This makes sense because of the time it took to shutdown windows and boot to the BIOS. And although I didn't check exactly, HMonitor shows the similar results as the BIOS for the other things it monitors.

Thereare no my BIOS is not set to shut off my computer because of CPU overheating. There are no BIOS settings for the fan. (It only reports the fan's RPMs.)

The annoying beep is no coming from the BIOS or the PC Speaker. It is coming from the regular speakers. From what I have observed, it seems to be the last 1/10 second of sound from the game repeated over and over again. (But it sounds like a beep.) I have concluded this because if a high pitched sound was playing the in game when it froze, the beep was high pitched. Low pitch, then low pitch. Loud, then loud. Quite, then quite. No sound, no beep.

by phil.hall

Ok, this is a stretch, but have you moved the sound card to another PCI slot on your computer? With you having already installed all the updates and the newest drivers, I'm thinking that (along with the 50C temp) that it's not your equipment but themotherboard...or perhaps that particular slot. Give that a try. Can't hurt.

by justme2007

I have tried that. Right now my sound card is in slot 3. I have tried it in slot 4. When I tried it in slot 4, it was sharing IRQ 11 with the video card when windows booted. I don't remember if windows reported sharing an IRQ. Either way, it didn't fix the problem.

I may try it in some of the other slots. (If I do and it does work, I'll make sure I tell you so I can give you the points.) But I since I've already tried this once, I don't think that this is the problem.

by dmiles

Check the graphics card manufacturers web site to see if their are nay postings that relates to this problem.
I still think taht it could be a memory related problem when the speed of the memory exceeds the FSB data rate speed transfer.

by nook99

If the freezing only occurs during playing 3D games, I would definitly suspect a problem with the ATI video card. Could be a video ram problem or a poor connection to the motherboard.

On my computer, the ATI video card did not fit into the AGP slot properly. I actually had to snip off part of the metal front plate to get it to fit snuggly and work consistantly.

If you have another video card available, try installing that and see if your problem goes away.

Make sure you have installed the latest AGP port drivers for your motherboard.

Agree with previous poster that ATI support & drivers are terrible.

good luck

by justme2007

THANK YOU! Although I found out that it was video RAM before I read this posting, I am still going to give you the points. I took my computer in to the guys I bought it from. They formatted, reinstalled, and ran some tests (3DMark2001 SE I think). The video card had bad RAM. So now I've got a new video card and everything is fine!

by choppit

If you have the option, try reducing the DDR clock speed in BIOS settings. Its possible that the RAM is flaky and folds under pressure. Although you've run RAM tests and they've passed they're usaully no substitute for real world gaming. I've been caught out a few times by cheap or badly matched RAM.

by trippin

Maybe you can try this..
Go to desktop, right click my computer , go to advanced tab , under performance , go to settings , and to advanced , give more paging file to your c:\ by clicking on the change below.
Try play your game...if can good luck!
If not go to your desktop, right click my computer , go to advanced tab , Go to enviromental variables ,edit your variable settings to C:\temp or where u want to specify. eg c:\temp ... u must have the folder created Temp.
edit both varibles,so they can point to the same file.
Try again.

Thank you
Let me know of the results.

by justme2007

It was a Video RAM Problem. Btw, My page file was already set for larger that Windows was ever using.

by digital_dna

What the heck I'll give it a try...

It's looks to me that you have already tried the first three things that came to mind (over-heating, Memory, power-supply).. I would double check the power-supply. If you have a spare one lying around plop it in, or test your current supply with a multi-meter.

Now on to my long-shot answer. I would check the CD-ROM drive to make sure all the connections are secure (data cable and power). If these cables are secure, remove and plug them back in.If that doesn't work and you have a spare CD-ROM drive lying around install that drive and check the system. That may sound weird (it did to me) but I had a customer who had a similar problem. The problem was the CD-ROM Drive. To this day I stillhave no Idear why that was.

Good luck
Post back when you solve the problem, I'm sure we would all love to know what it was.

ebcdic

This discussion is closed to new replies.