Discussion Locked

Gateway pc wont start up

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I recently came across a gateway 633c desktop that will not boot up. The power button does not turn a solid green, it is yellow. It does not even detect nor show anything on the monitor or give lights on the keyboard. Just the steady yellow power indicator. Could this be power supply related?

5 replies

by ltop

Hi,

The power light on the monitor is what your refering to when you indicate it remains yellow?

This should indicate the monitor is getting power but no signal from the desktop.

What about any indication from the desktop itself?

The power and hard drive indicators on the desktop case show any lights ?

Any noise from the hard drive spooling up - any fan noise.

If there is indication from the desktop that it is actually starting up (by way of some noise) it may be the video card or on-board video that is the problem.

If there is no indication that the desktop is starting up, is it actually getting power?

Hope I can help further

cheers

by dmiles

The problem could be the CPU is gone,there is not a signal to process the instructions,try another cpu before proceeding.

by hal 9000

First disconnect the reset switch at the front panel connections and see if it still is staying the same. It's not unknown for these to jam up and stop the computer booting as it is constantly in the reset state.

Col

by willcomp

Troubleshooting 101

The first rule of troubleshooting a PC that will not boot is to reduce components to the fewest number possible.

Disconnect power and signal cables from all drives. Remove all cards except video card.

Try a boot. If successful, sequence components back one at a time.

If no luck, change out power supply. If still no luck, motherboard voltage regulation circuit has probably failed and mobo replacement is required.

To possibly save time, inspect mobo capacitors for signs of bulging or leakage. Tops should be flat and no leakage. Pay special attention to ones near CPU socket. If bulging or leakage is present, problem has been identified.

Dalton

by neil cotton

Pay special attention to Dalton and Collin's answers.

Very nice...troubleshooting 101 - i like it

This discussion is closed to new replies.