Question Locked
0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I am getting a green screen on a moniter that is running over a cat5 cable using a vga to cat5 balun. What could be causeing this?
7 replies
by hcetri Accepted solution
Clarifications
by cmiller5400 Accepted solution
Interference? Bad VGA cable? Bad VGA->CAT5 converter?
by hcetri Accepted solution
Could it be the wires in the cat5 in wrong location in keystone jack?
by robo_dev Accepted solution
Since the display is RGB, you've lost the R and the B signals, but your G is good.
Look for the words "made in China" on your convertor box....if your cabling did not change, and your monitor and cable is good, then your convertor box has failed.
by hcetri Accepted solution
The convertors are brand new just installed 2-2-08. I had to wire the jacks. I tried a LG tv using the pc input on the same wire and it worked fine.
by cmiller5400 Accepted solution
If a pair were reversed or open it may cause funky things. Best bet is to test the cable with a cable tester to see if it is a straight through network cable.
by hcetri Accepted solution
Thanks I'll check the wires.
This discussion is closed to new replies.
Trending Desktop posts
Sort by Trending
Question
Floppy drive wont work on my 486
0 helpful
1 reply
Discussion
How to make light speed agent go away
0 helpful
4 replies
0 helpful
1 reply
Discussion Locked
Ryzen 7 7700
0 helpful
2 replies
Question Locked
Issue fully resetting my PC
0 helpful
4 replies