Discussion Locked

Hard Drive Upgrade

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

My motherboard support UDMA/33. I already had ATA/33 8G Maxtox on the system. If I want to add one ATA/66 13G to the system. Is this possible? If so, What will I do? Upgrade BIOS? Use one IDE port for ATA/33 and another for ATA/66? or buy a PCI ATA/66 for 13G HD? or use both HDs on one cable?

Thanks for advance.

11 replies

by rolando_manuel

Your hardr drive will run on your motherboard without any problem cause this ATA technology supports downward compatibility. only, you will utilize a performance of upto UDMA/33 cause this is the maximum mode that your mainboard supports. you can either slave it or put it on the secondary channel.

by gstratto

The best way to do this is to buy an ATA66 Promise card.. Roughly AU$60 and install this into your system as per the instructions..
Then connect your HDD that is ata66 compatible (7200 rpm)to the promise card that you have just installed.
If you have installed the card right, it will automatically pick up the 7200rpm HDD
if you only have 5400 rpm HDD's then they will run at ata33 speed even if connected to the ata66 Card.

by raymond l pennington

Although answers 1 and 2 are correct that you will be able to use the drive (backwards compatibility of ATA/66 )I would check to make sure your MOBO will support a 13-gig drive first . If not it maybe a simple BIOS update but the only way to get that ATA/66 enhancement would be a Hardware change I.E. Promise Ultra/66 controller or New MOBO . :(
(It cost to be on the cutting edge of Technology)

by fred_e944

Without a new motherboard or ATA/66 PCI card you just plug in the new drive and use it as ATA/33. Maxtor drives detect automatically if the controller is UDMA/66 capable. WD drives have to be set with software (Data Lifeguard Tools, download from WD's website).

I have my doubts about any performance increase with controller cards because the PCI buss is still 33MHz, even if data is coming in from the disk at 66MHz.

by kevin.reed

Yes you can add an ATA66 to your system but will only operate in ATA33 mode. Be aware that some motherboards have problems running ATA66 drives at ATA33 but Maxtor has programs on their site to rectify this. You may also have a problem running a hard drive over 8.3GB. The BIOS may only see the 13GB as an 8.3GB. Once again Maxtor has fixes for this on their website.
A BIOS update may remove the 8.3GB barrier if your motherboard has it, but will not allow ATA66 speeds.
Would recommend buying one of the available ATA66 IDE controllers that are avilable, easier in the long run plus you get the benefit of ATA66 speeds.
The url for the Maxtor utilities I mentioned is
http://www.maxtor.com/Maxtorhome.htm

Hope this helps

This discussion is closed to new replies.