11 replies
by parbo
by danfalconar
I am thinking maybe the jumpers are set up incorrectly? Just a hunch. Check them out, maybe they need to be set up differently for a different operating system.
Troubleshooter.
by danfalconar
by lo
Even SP4 may not resolve. I did same/similar with 2 20gb (one for DriveImage Backups). Initially the primary showed 8gb, backup showed 20gb. I forget the exact solution (will get it again, am having same problem since I reloade a DriveImage a fewmonths back and got back an 8gb on a 20gb).
I think I used Partition Magic (v6 or >), created unused space at beginning to hold parttition (3) and did an Extended for the remainder. This worked, had both reporting 20gb. With current config, 20gb primary and 60gb secondary, the 20gb shows 8gb. If I create an Extended Partition, I get BSOD, delete it and it works OK.
by danfalconar
by dmiles
The generic IDE driver (ATAPI.sys) may not be compatible with drives larger than 8GB,yet service pack includes a updated ATAPI.SYS allowing access to disks larger than 8GB.
Download the updated Atapi.sys from Microsoft's FTP server,
ftp://ftp.microsoft.com/bussys/winnt/winnt-unsuped/fixes.nt4.0/atapi/ATAPI.EXE and copy file to a blank floppy disk and run ATAPI.EXE,to load files from disk.
by danfalconar
by drew_lgca
The system partition (boot partition) is still limited to 7.8GB whether an updated version of the Atapi.sys file is installed or not. See http://support.microsoft.com/support/kb/articles/q197/6/67.asp
So get the rest of your drive you could make several partitions. I was told that if you have NT install on another PC and then install your 20 gig drive as a slave and then format the drive and then re install NT that you can get large drives to work. But I have never tried it.
by danfalconar
by danfalconar
This discussion is closed to new replies.
Trending Desktop posts
Sort by Trending