Discussion Locked

HDD Error Message

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

During my boot up, there is a hdd error message. I am using maxtor hdd with NTFS file system. How am i going to solve that? I can detect my hdd in bios but the status of my hdd clyinder was incorrect.

Any idea to help me solve this problem, i got some important data in it.

4 replies

by skidoggeruk

You could possible set CHS information manually in BIOS. (make a note of existing settings)You may find this info actually printed on the drive itself, failing that have a browse on manufacturers website or have a Google.

Some BIOSs detect multiple CHS settings, allowing you to try a different one in turn. You could try that as well.

If the failure is during OS boot, what is the message? IE "Sector not found" etc

Good Luck

by blackcurrant

Hi

If you need to get the data off it fast, then take the HDD out of your machine and install it as a secind hard drive in another machine (preferably with the same OS). Grab your data off it, then check the HDD for errors.

Good luck

by nickytangy

At the bios boot up prompt (HDD Error) message.

I went into bios setup. It detect my hdd with wrong status eg; actual cylinder is 16383 but is shown 36338

This discussion is closed to new replies.