Question Locked

how do i get my usb ports to work?

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I recently bought a compaq presario (used) and when I plug something into the usb ports the computer wont even power it up let alone read it. How do I fix this.

6 replies

by oh smeg

But have you looked in Device Manager to make sure that the USB Driver is installed?

That would be my starting point.

Col

by phonethiri

1) first check you have already installed necessary USB Driver for the thing you plug.

2) If you already installed necessary USB Driver, I think your plugged usb drive might have same drive letter with some installed drive ( eg. E: , F: ).

Please make sure you can see your device in Device Manager.

If you can, then change the drive letter (eg. to H:) in the Disk Management for your new device (for example. you might see as Removable Disk).

Thanks.

by graynett

I had a similar problem when I installed more then 26 (or more) different Devices in the same USB port. From Cameras to printers and memory sticks I then tried to replace my web cam in the port Nothing! It was a permission thing in the registry easy to fix if you can find where the permission is required took a long time to track down the cause through knowing that was the fault, helped! {HKEY_Current _config\system\currentControl|setcontrol\Enum\USB\]} [ Some where there to give permissiom]

by bob.wasson

This is a long shot, but...
If your c: drive is encrypted it may not allow you to boot up while another potential OS drive is attached. If you can boot into windows with it plugged in, you should go to device manager and confirm that your usb ports are alive and well. I hope this helps-

by Member 26632525

Probably the system is configured to boot from usb drive first, then hd. Check the bios setting (boot order).

This discussion is closed to new replies.