Discussion Locked

How to bypass " Password On Boot"?

0 helpful
10 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
My computer is configured to boot from Hard Drive first and passowrd protected on boot.. I lost my password ..how can I bypass this password and log on to my Computer? any suggestions ? any tricks either hardware or software? or, do i have to reformat the hard drive and lose all the data?

10 replies

by kaybar1095

The following usually works for the initial log in password: find the name of your mother board and from their web site or your documentation get the jumper position to boot without password. open your case, move the jumpers. turn your machine on and you will now be able to access the set up menu and you can change your password.power off and return jumpers to original position

by yellow_sea

I am running two partitions ..a 20 GB Partition Windows XP Pro and a 10 GB Partition Linux Red Hat 8.0 and a free space of 10 GB

by yellow_sea

My setup is protected by the same Password...so does working with hardware and the jumpers enable me to log onto my setup given that it is also password protected?

by hal 9000

No in that case it will not cure your problem as the Passwords are Software Passwords not hardware related Pass Words.

You might find one of the listed utilities at this site useful. As they are the same pass word for both I would start with the Windows one as it's much easier to crack.

http://tinyurl.com/heosl

Or you could try this TR article and follow some of the discussion for more cracking tools

http://tinyurl.com/jedbf

Col

by searchme1234

Just remove the bios battery from the mainboard and disconnect all power supply for 2 min.

After that u can download a password recovery utility from net, burn it on a CD & the disable it through the CD.

by the hive

Go to your motherboard manual and see how you can clear the CMOS with the jumper setting.
It usually has these steps:
1. Turn off your PC and unplug the power cord
2. Remove the CMOS battery
3. Move the jumper caps from pins 2-3 (the clear cmos jumper has usually 3 pins)to pins 1-2 and keep for 10 seconds, then move the jumper back to pins 2-3.
4. Re-install the battery.
5. Turn on the PC.

by wangwh

If you have access to the hardware, you can try resetting the BIOS jumper setting on the motherboard. I have done it once and it works.

by wpsabrina

Hey, I also got locked out of my computer several days ago. I tried several free software. It took me two days and got quite messy. Unfortunately none of them work for me. Finally I made it work with password genius. The good news is that it works. The bad news is it is not free.

by wpsabrina

Hey, I also got locked out of my computer several days ago. I tried several free software. It took me two days and got quite messy. Unfortunately none of them work for me. Finally I made it work with password genius. The good news is that it works. The bad news is it is not free.

This discussion is closed to new replies.