Discussion Locked

how to get out of dos compatibility mode

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

when i go into system-performance it says that i have dos compatibity mode paging activated and it is slow down my machine. the machine is a pentium pro 200/138Mb ram.
how do i ix it.i have tried everything that i can think of. please help.

9 replies

by poettone

Alot of these types of problem can be traced to an old outdated Motherboard bios. Also could be a disk drive that will not or cannot have LBA enabled. Im guessing that you are using win98 operating system. If so try to enter the bios and check your settings for the hard drive. You might have to reformat your drive and configure it differently. Also you probably have more than one drive installed which with certain installations can cause this. Also in that same area you can under trouble shooting disable 32 bit disk access and see if that clears the problem . If it does than probably a drive problem.

by smltec

If you are running win98(and by the way your question cant be answered completely unless you tell us what your os is)click start>run and type msconfig {ok}at the general tab put a dot next to selective startup/remove the checks from process config.sys and process autoexec.bat/click apply and ok and reboot/then check performance again/this disables dos compatibility

hope this helps

by samsarijan

Your problem is due to the wrong drivers and utilities you had installed for the MOBO. I assume that you use the Windows 98SE OS.
During Windows start-up, go to safe mode by pressing F5 and delete all the duplicates and conflicting devices in the Control Panel/Systems/Device Manager. Also delete all the duplicate and conflicting devices like motherboard resources and PCI steering devices. Restart and reinstall all the right drivers for the motherboard especially hard disk and floppy disk controllers.
The problems should go away.
Good luck

by whoroo

A good config.sys will have nothing in it. Clear out Autoexec.bat. Remove any item from the Win.ini run line then restart your machine. Make Windows look for your devices instead of reading your old set up.

This discussion is closed to new replies.