Discussion Locked

HP CD Writer and drivers for Win2000

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I just bought a hewlett packard and it came with a dvd/cd/cdrw drive. It had Win 98se installed. I upgraded to Win 2000 and cannot find the proper drivers for the burner. Any suggestions? I have called HP and they are NO help whatsoever. I alsocontacted the vendor where I purchased the computer and they did not know where to get the proper drivers for this device. They also called HP too. No luck! Please Help!

7 replies

by bstei18

HP does have some drivers and flash upgrades for these drives on their support site, however, you may have to fork over $9-$25 bucks to get them. I believe you get the updates for the programs when you purchase these. When I found this out I decidedto hold off on buying an HP for a while.

by protomatter

Hi there,
I would put good money down that if windows 2000 reports the correct drive name and model you don't need drive specific drivers. Go to the control panel, then to the system applet, to the hardware tab, then open the device manager. Expandthe DVD/CD-ROM section and see if the CD-RW/DVD is what you expect it to be.
If so then you probably only need to install a burning program, such as Easy CD Creator 4 from Adaptec. This program is compatible with just about every burner on the market, and a version of it probably came with your burner. All you have to do is configure it to use your burner drive, and you are all set. I know this works since we recently resolved this issue on several machines.

Hope this helps,
proto

This discussion is closed to new replies.