5 replies
by douglasb
I already checked the cables/wires (noted in problem). The computer should post even if the harddrive is bad.
by balbir
If the above answer fails to resolve your problem
try the following:
If you have access to a multimeter, switch the multimeter to read Ohms.Disconnect the two pin connector that goes to the motherboard from the power switch and with the meter probes connected to the two leads from the power switch push the power switch. It should read short circuit on the meter( Zero Ohms)If you don't have a multimeter, or if it sounds complicated, remove the two pin connector from the power switch to the motherboard and short the two pins with a screwdriver tip.
MAKE SURE YOU ONLY SHORT THE TWO PINS THAT THE POWER SWITCH CONNECTS TO.
If the pc bursts into life, you have damaged the power switch or the lead has come off the switch.(sometimes the lead is disconnected but still inside the black sleeving-try pulling it slightly)
Balbir
I tried the above - obvious when you stop and think about it - the button was fine I think the MB is now bad. I've since replaced the computer and added the HP to the landfill.
This discussion is closed to new replies.
Trending Desktop posts
Sort by Trending