3 replies
by dave
Just a thought... are the serial ports enabled in the BIOS? they sometimes still report as being installed within windows even when they have not been enabled in the BIOS.
If both are enabled and are visible in windows it may be worth looking into a Serial >> USB adaptor which would get round any board problems.
by hal 9000
Well the above answer is the obvious one but you should also look in the System Management to see if the serial ports are not only present but available. They can sometimes be a hardware conflict which prevents them from working correctly. This can either be set from BIOS or in Windows depending on the make and Model of M'Board. The speed of these ports can also be a critical factor and again first needs to be set in BIOS and then pushed up to their max speed in Windows. If they are set to a low speed it is possible that XP will not detect the connection when the camera is plugged in and also you'll need to have the camera plugged in and turned on at Boot up as if Windows can not find any available hardware on these ports with SP2 it locks them down and renders then unusable. It may have been the case before SP2 as well as I seem to remember a external modem not being recognized on a XP SP1 computer unless it was turned on at boot up I think it was MS way to prevent unauthorized access to the computer by locking down unused ports. Try that one first before trying anything else just turn on the camera and reboot and see if XP runs the Found New Hardware Wizard.
Col.
by willcomp
The very obvious: Is camera turned on and set to data transfer mode?
Dalton
This discussion is closed to new replies.
Trending Desktop posts
Sort by Trending