Discussion Locked

I can't get my floppy drive to work

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Recently,I had a problem with my floppy drive,so I replaced it with another one from a computer no longer used.When I look under "My Computer",it shows 2 floppy drives,one as the A:drive and another as an F:drive.I try to read a disc in the one,but neither of them say anything is on the disc.I went into DOS,and it was able to read what was on the floppy(A:drive).How do I get my system to recognize my flopyp drive,and how do I delete the extra F:drive on "My Computer"?

7 replies

by dmiles

One connect the floppy drive to the first connector on the ribbon cable
Reboot the computer and press the key to enter CMOS panel and check the configurationto make sure that only the A drive is enabled
Reboot computer and check scan the boot floppy for viruses
Open the Device Manager and go down the list to the floppy drive and click on the (+) and check to see how many floppies are listed and if the floppy is duplicated,delete one and reboot the computer and see if this will clear up the problem

by thechas

It puzzled me for a while as to why Windows would assing a floppy as drive F.

Is the new floppy a standard 34 pin floppy, or a 40 pin IDE device?

If it is a 40 pin IDE device (LS120), you may need drivers and it may need to be the master device on your primary IDE channel.

If it is a standard 34 pin floppy, I would remove both drives from device manager,
Make sure that the box for check for new floppy drives is checked, if you have it, (In W98 it is at system, performance, floppy)
When you reboot, go into setup, and make sure that the bios is set for the correct drive type, and that in advanced properties that it is set to report new floppy drives to Windows.

by douglas_debow

We need to know win ver on your system first.
in win 95 there were problems reporting the floppy.
if this is the case. there is a switch in the bios for floppy reporting for win 95

by douglas_debow

try going to system properties
then device manager
open floppy disk
if there's two try remove the second one and
let us know what happens

by petrispaz

I am running Windows 98 on my PC.I have tried the first 2 possible solutions,but it still is showing 2 floppies.And again,when I go into DOS,it will read what I have in the floppy drive(A:),in terms of the disc.Thanks for the suggestions though.

This discussion is closed to new replies.