5 replies
by csmith
Installing and removing a MODEM, Sound Card, and NIC will not affect the BIOS settings.
The usual cause of boot failure after doing this is a loose/damaged Hard Drive Cable.
Some PCs have very little room to work, and some cables are poorly made.
It is easy to cause this problem, in this case.
Check/swap the cables for the Hard Drive and the Floppy Drive, and set the BIOS to Halt on No Errors. The source of the problem should become obvious.
Regards, Chris
by m_grande
by yagar
In the BIOS of the board ( I am looking at a P2B-F so it may be slightly different)
In the "BIOS feature Setup" Screen
the "BIOS update" is enabled
In the "PNP PCI" setup screen
PNP OS installed is set to "NO"
Slot 1-x are all set to "AUTO"
All the IRQ and DMA are set to No/ICU
If these were all set correctly or booting does not change anything
On the first screen of the BIOS there is a "LOAD BIOS DEFAULTS" do that.
e-mail me if you need more help
by m_grande
by m_grande
This discussion is closed to new replies.
Trending Desktop posts
Sort by Trending