Discussion Locked

i/o conflict in nt 4.0

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

..sorry for this newb question, i hardly ever use nt 4.0 ...

I've got an I/O conflict between a NIC and a gfx adapater. Readme files and support sites of both manufacturer simply state:
Realocate the I/O address of one of the devices...

How can I do this under Nt 4.0 ? I can see all the resource allocations, but can not find information on how to change them.

ta
luds

5 replies

by estebandelatorre

Look under control panel, for an icon related to one of the cards (like the the multimedia icon. From there you can change the IRQ , DMA, etc)
If not, surf the web of the nic and gfx adapter in order to find how to change it's default configuration.
Another site may be under bios properties, disabling PNP and asigning manualy IRQ and Block MeM. to each legacy card

by curacao_dejavu

If the cards have jumpers , try changing the settings on the card first.

If you have a isa card change it to a pci card or try the following.

Windows NT 4.0 does not support Plug and Play.

RESOLUTION
The driver library on the Windows NT 4.0 CD-ROM includes the PnP ISA Enabler driver, which may allow the detection and installation of Plug and Play devices in Windows NT 4.0. Install the PnP ISA Enabler driver (PNPISA) using the following steps:

NOTE: Although Windows NT includes PNPISA to detect Plug and Play devices, Plug and Play devices are not supported in Windows NT 4.0. PNPISA is provided as a "use at your own risk" tool.

Locate the Pnpisa.inf file in the Drvlib\Pnpisa\ folder on the Windows NT 4.0 CD-ROM.

Right-click the Pnpisa.inf file, and then click Install on the menu that appears.

Restart your computer.

After you restart your computer, you may receive a message that Windows NT has detected your Plug and Play device(s).

This worked form my old SBAWE32 card.

regards,

Leopold

This discussion is closed to new replies.