Question Locked

IBM Intellistation Z-Pro Won't Boot!!

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I'm building a workstation from a barbones IBM Intellistaton Z-Pro. I installed dual 2.6Ghz Xeons and 2Gb RAM all tested and working. On startup I get a beep error code of 2-2-3: CMOS power failure and checksum checks failed. It then starts to post and reports the following
error codes:

162: Invalid Configuration Info or CMOS RAM Checksum Failure

184: Bad Power on Password

It then promptly shuts down. I've tried everything I can think of. Replaced the battery
Cleared the CMOS by moving the jumper. I can't flash a new BIOS as it won't stay on long enough. I'm starting to think perhaps I have a bad mobo?

Any thoughts would be greatly appreciated!!

TIA.....Cristofe Chabot
Stonetree Productions

2 replies

by kjcleve

unplug computer.
unplug power source from motherboard (the atx connectors)
remove cmos battery.
on the 3 pin connecter by the cmos battery with the jumper on it, move the jumper to the "other 2" pins to ground out your bios. with all electricity gone, it should loose its charge and be reset to factory.
replace jumper back to initial 2 pins
install cmos battery
connect power connectors from power supply to motherboard
connect power cord
press power button
hopefully it boots now.

This discussion is closed to new replies.