Question Locked

IBM Thinkpad- headwrecker time

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

OKay after a teardown, clean and reassembly, my Thinkpad BIOS was reset. The FN keys that dim or brighten the display seem to be screwed.

The adjustment usually runs in about 5 or 6 increments, dark to light. As you use the FN keys with the brightness control keys (HOME/END)it goes from DARK to LIGHT on each step. Instead of increasing in increments, it's almost like an OFF/ON situation where the graduations are not working.

Details:
Thinkpad R31-2656EEU, PIII 1.13GHz, 640 MB RAM, WIN2K.

I am quite sure it is a BIOS setting or driver issue as the settings were wiped out during reassembly, all drivers have been updated, chipset, display, AGP, FN key access etc.

IDEAS??

6 replies

by oz_media

And that's a good thoughttttttttttttttttttttttttttttttttttttttttttttttttttttt. :)

Thanks

by mdphoenix

If I had this situation, I'd first check for a firmware update. If that didn't help, I'd download the original Thinkpad utilities from IBM's site and see if that did the trick.

Short of that, I'd stick another hard drive in the unit and perform a new install and see what I can figure out. A simple teardown shouldn't have caused this (obviously or you wouldn't be here, right?). I'm really thinking software as opposed to hardware. Do you recall if you could incrementally adjust the brightness outside of the OS ie: in BIOS or during boot?

by oz_media

As noted, I've done all the latest updates from IBM. When cleaning the fan, you need to remove the CMOS battery to get to the screw underneath a little clip. I've done the same clean periodically (onnce or twice a year) for a few years now, there are always a few BIOS settigs to revert and I always get new updates from IBM/Lenovo.

TO explain further, whlie holding FN key down, you can use the HOME key and each tap elevates the screen brightness one notch.
Since the rebuild, when holding CTRL you hit the hoe key and it goes to full brightness (showing the first increment in the brightness guage. The next keypress dims it until almost dark. The next keypress and it's bright again, then dark on the next.

Each time, the guage is showing it has brightened by one increment. It's just that 's it seems to go from Full bright to dark for each increment, instead of a gradual increase each time.

Thanks for your reply, I appreciate your input.

by mdphoenix

Does the rest of the keyboard work ok? Maybe reseat the kbd connection?

This discussion is closed to new replies.