Discussion Locked

illegal operation

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

my netscape always shows 'illegal operation'.i've already reinsatall it but it use to show the same problem.
i also use internet explorer in my pc.
please help me.

9 replies

by dmiles

Thes may help
Click on Start.Programs,Windows Explorer,in left pane click on Program files,click Netscape,then users,then file with your name on it delete the cache,and temporary files folder,rename the cookies.txt to cookies.old
Reboot the system.

by m.cothran

Hello im here to Help!

When you attempt to shut down your computer, start Windows, or start a program in Windows, you may encounter error messages that are similar to:

A fatal exception XY has occurred at xxxx:xxxxxxxx
Fatal exception errorsare codes that are returned by a program in the following cases:
Access to an illegal instruction has been encountered

Invalid data or code has been accessed

The privilege level of an operation is invalid

When any of these cases occurs, the processor returns an exception to the operating system, which in turn is handled as a fatal exception error. In many cases the exception is non-recoverable and the system must either be restarted or shut down, depending upon the severity of the error.

In the sample error message that is listed above, XY represents the actual processor exception from 00 to 0F. (Note that the "h" that is listed after the 0E, 0F, and so on, in the explanations below is frequently omitted from the error message.) The xxxx:xxxxxxxx value represents the enhanced instruction pointer to the code segment; the 32-bit address is the actual address where the exception occurred.

Windows does not cause these errors, but has the exception-handling routine for that particular processor exception, which displays the error message.

by m.cothran

Try a clean boot! To do this, do the following!
Start System Configuration Utility at the Run command. To do this, click Start, click Run, type msconfig.exe in the Open box, and then click OK.

To use System Configuration Utility to perform a clean boot, use one of the methods that are mentioned earlier in this section to start System Configuration Utility, and then follow these steps:
On the General tab, click Selective Startup, and then click to clear the following check boxes:

Process Config.sys File
Process Autoexec.bat File
Process Winstart.bat File (if available)
Process System.ini File
Process Win.ini File
Load Startup Group Items

Click OK, and then restart your computer when you are prompted to do so.

When you click to clear check box for a file, a "remark" statement is placed at the beginning of each line in the file. For both the Config.sys and Autoexec.bat files, a "rem tshoot" statement followed by a space is placed at the beginning of thelines in the file for the check box that you click to clear. For both the System.ini and Win.ini files, a "; tshoot" statement followed by a space is placed at the beginning of the lines in the file for the check box that you click to clear. These remarks are removed when you click to select a check box that you previously clicked to clear. When you click to select a check box for an item on the Startup tab, the registry entry is restored to its original location.

This discussion is closed to new replies.