7 replies
by vanteks1 Accepted solution
by w2ktechman Accepted solution
by oh smeg Accepted solution
The problem here is the Power Supply. When they are over stretched you get a No Signal Available message on new Monitors when the Computer is turned on.
When this happens replace the PS with a higher powered one and preferably from one of the better PS makers like Antec and do not use the no name brands which only are rated to Peek Values not constant Load Values.
Col
by w2ktechman Accepted solution
Hmm, must make a note of this. However, I primarily work on pre-built business class systems from manufacturers, which may be why I havent seen this issue.
Oh yes, I agree, Antec is the only PS that I use for my stuff.
by oh smeg Accepted solution
But I had one system that I build for a Business returned but only after the owner had replaced the M'Board, RAM, Video Card and CPU. When power was applied the monitor showed a message that there was no signal or that the Video Lead was disconnected. I replaced the PS and it worked which was slightly galling to the guy in question as he had bought all of these parts because he didn't want to pay me to fix the computer. Pity that he didn't save anything and wasted a lot of money but that had a Antec PS in it and it wasn't one of the bottom of the range ones either.
However on the up side only the PS was damaged in that case and when it was replaced everything worked perfectly. Pity that the rest of the computers in the building didn't though they all needed new PS, and basically everything inside the case replacing. They had a truck hit a power pole and bring the High Voltage into contact with the Mains Supply. And the one that I built was the only one that cost under $100.00 to repair. :D
Funny thing but after that I do all of their work now and supply all of their hardware. They very quickly worked out that saving a few hundred $ on the original purchase was no saving when something went horribly wrong. They only had the one computer in the building that worked from the repair which took less than a 20 minutes to fix once they called me. ;)
Col
by vanteks1 Accepted solution
I replaced the power supply with a new one.
Now i've got video. But now I have a new
problem. I'll make a new post of it.
by ---tk--- Accepted solution
This discussion is closed to new replies.
Trending Desktop posts
Sort by Trending