Discussion Locked

Installation of AGP Video Card...

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have this really big problem, I have to install an NVida GForce 128 MB AGP graphics card. This is what happens, I isert it into the AGP slot on the MB, but I get no display. The MB is a SOYO SY-P4VGM v1.0. How do I install the card? How do I disable the onboard VGA from PCI to AGP?

8 replies

by cyberghost_1

I changed the VGA in BIOS to AGP from PCI, with MILD success. I get as far as the Win XP Logo and then the screen stays black. it doesn't turn off, just stays black. What next?

by thechas

Hi Juan,

The Black screen after the Windows logo tells me that the default video setting is not acceptable to your monitor.

If you have a different monitor, try it and see if you can then complete the boot process to install the video card.
I recommend installing DirectX 9C and the latest driver from nVidia's web site.

If you only have the one monitor, or don't have one that works, then,
Switch back to the on-board video.
Boot up into Windows.
Remove both your monitor and the display adapter from Device Manager.
Shut down and switch to the new video card.
You should boot up into a default mode that will allow you to install the drivers.

1 more thing. This motherboard only supports 2X and 4X AGP modes. Make sure that the video card supports the proper mode.

email me if you have any more questions.

Chas

by dmiles

First check to see if the MB is compatible with the Graphics card,does the board support AGP 4x 0r 8x

Boot computer when the startup screens appears,press the designated key (DELETE) to enter the bios setup
Select the Advanced menu,scroll down to graphics card setup,right click on the graphics card,then click to disable
Select to Exit and Save changes

Now install the card in AGP slot,proceed to install the software drivers.

Hope this helps

by csmith

Changing the BIOS setting to AGP solved the hardware setting problem.
Now to the software problem.
WinXP is still using the old video driver.
I assume this is in spite of your removing it.

Solution: (Quickest) Boot into "Safe Mode" and load new videocard driver.

If no can do, (Slower) go back to onboard video, load new video driver, shut down, reinstall new video card and boot.

Regards, Chris

By the way, you can leave the on board video enabled and run two monitors on the PC.

This discussion is closed to new replies.