Discussion Locked

Installation of AGP Video Card...

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I need help installing an NVIDA 128MB graphics card. Its AGP not PCI. After installing it to the motherboard, the cpu turns on, but the monitor stays off. What is the deal. My motherboard is a SOYO SY-P4VGM v1.0, I am using WIN XP pro, 512 MB RAM, 17? CRT. Origionally the graphics are controlled with onboard graphics..PRO SAVAGE DDR. How do I disable this to install the GForce? I tried uninstalling it and then plugging in the GForce, with the same results....Please help....

5 replies

by willcomp

These steps apply to most newer BIOSes.

With monitor connected to on-board video:

1. Enter ROM BIOS setup.

2. Go to Integrated Peripherals

3. Change Initiate Display First to AGP instead of PCI or Onboard.

4. Reboot with monitor connected to AGP card

That should do it.

Dalton

by dmiles

Boot computer when the startup screens appears,press the designated key (DELETE) to enter the bios setup
Select the Advanced menu,scroll down to graphics card setup,right click on the graphics card,then click to disable
Select to Exit and Save changes

Now install the card in AGP slot,proceed to install the software drivers.

Hope this helps

by csmith

Changing the BIOS setting to AGP solved the hardware setting problem.
Now to the software problem.
WinXP is still using the old video driver.
I assume this is in spite of your removing it.

Solution: (Quickest) Boot into "Safe Mode" and load new videocard driver.

If no can do, (Slower) go back to onboard video, load new video driver, shut down, reinstall new video card and boot.

Regards, Chris
By the way you can leave the onboard video chip enabled, and run two monitors on this PC.
WinXP just has to have the video drivers for both video chips, and the monitor priority in XP has to match the monitor priority in the BIOS.
I recommend making the AGP video the first priority.
Also, sometimes VGA pallet sniffing has to be enabled with two monitors installed. (Chip dependent)

by trockii

Make sure you check the jumper settings on the motherboard to disable the on board video. I know it's simple but looked it's often overlooked.

by doobiedoobs

Hi,

You might also need to uninstall the old driver of your onboard display but most of the time, there is jumper somewhere near the agp slot that you need to replace in order for the graphics card to work. It should be stated on the manual so check it out. Hope that helps.

-Doobiedoobs

This discussion is closed to new replies.