Question Locked

Interesting Wireless Issue

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have two computers using wireless at home, one being a desktop and the other a laptop. The desktop has never had a wireless problem but the laptop drops the connection "randomly"--anywhere from 1 to 10+ times a day. In the router's log it says this at every disconnect: wl0: 11g : DeAuthentication (rcvd. station leaving). The signal strength is fine, and this seems to happen regardless of where the laptop is in my home. What really gets me is that I've taken this laptop to friends' homes and wifi hot spots around the state and never had a problem. Does my laptop's adapter just hate my router?

Laptop has SMC 802.11g 108Mbps card.
Router is Buffalo Wireless-G MIMO.

Thanks in advance.

2 replies

by nepenthe0

Check the wireless signal strength in the laptop's adapter monitor. If the signal strength is <50%, you may lose connection with the access point. Vertical router antenna boosters can increase the horizontal signal range by ~50%.

To thest this hypothesis, operate your notebook within the same room as the router. If everything works OK, you have just diagnosed the problem.

Also consider 2.4GHz radio interference from devices such as cordless telephone base stations. One workaround is to replace the 2.4GHz base station with one that operates at 5.8GHz.

Finally, look for other routers in the area, and determine their channel. If another router is broadcasting on channel #1 with 30% signal strength, and your router is broadcasting on channel #3, there could well be bandwidth interference. You should select a router channel that is separated from a competing signal by at least 5 channels. If the competing router is broadcasting on channel #1, you should program your router to broadcast on channel #6.

I have encountered problems with encryption, but usually such problems involve initial connection, not dropped connections. If you are using encryption, consider this alternative:

a) disable encryption

b) specify the MAC address for the computers that you wish to allow on the network. For Linksys () click Wireless > Wireless MAC Filter > check the box 'permit PCs listed below to access the wireless network'.

If you can safely get by without encryption, this will simplify your access as well as improve transfer speed.

Rick/Portland, OR

This discussion is closed to new replies.