Discussion Locked

Inteternal Zip Drive Conflicts

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I installed an internal zip drive on a brand new computer and when I rebooted it, the cd rom (where I slaved the zip drive) no longer had power, and it said both drives weren't there. I made sure that both ide controllers were enabled, and the cdrom was master and zip was slave, but neither of them work. when I take the zip off the daisy chain, the cd rom works fine. what could be the problem?

9 replies

by rgrowcock

Two things to try if you haven't already. A new IDE cable or maybe you are over taxing your power supply. I doubt that it is the power supply, unless you have lots of internal devices. Also, if available, can you attach the cd rom to the primary IDE and the zip to the secondary? Both would need to be primary unless you already have something else as the primary.

by bv2

Make sure that your cables aren't loose, and that your power cables are plugged in firmly. Also make sure (hope I don't insult you here) that your cable is correctly plugged into the zip drive - if it's plugged in backwards, the CD-ROM drive will not work. As an alternative, if you have only one HDD, slave the CD-ROM to that and set your Zip drive to Master on the Secondary IDE. Good Luck!

by rockyolson

Hi one thing I might suggest is to make sure that you have the cd-rom on the last or end plug of the ribbion cable if you do not I believe you will get this problem. rockyolson@charter.net

by bryan guffey

There's a pretty good chance that the (unneeded) DOS Compatibility Mode drivers are loading. Go into your system properties under "performance" tab and see if there's something like "MSDOS compatibility mode drivers reduce overall performance".

If you see that, try renaming your config.sys and autoexec.bat files to config.hld and autoexec.hld. Reboot and see if it all works. If it does, pick through those files to find the conflicting drivers and REM them out.

Best of luck,
Bryan

This discussion is closed to new replies.