Discussion Locked

Keyboard Problem?

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

My computer seems to be having a problem finding a keyboard. It does work though, I have a Logitech USB Cordless keyboard and mouse. My event viewer comes up with a warning, the source is "i8042prt". The discription of the warning is "The keyboard device does not exist or was not detected". Does anyone have any insite to this problem?

Thanks in advance.

C-

11 replies

by kgosnell

I experianced a problem very much like this, and the simple answer is that there is two connectors, side by side, exactly the same, one is for the normal mouse, and the other is for the key board, reverse them and it can't find the keyboard. Soo , likely you have the keyboard in the wrong slot, just move it to the other one and see what happens.
I hope it's that simple, as we tend to see such difficulties as complicated, which most are not.
Luck to you

by shanghai sam

But alas, That would be the first thing I would check if I had a ps/2 keyboard or mouse. As for USB, which is what I'm using, it shouldn't matter, but I moved both the cables back and forth just to make sure. Thanks though.

by rwayne

I have a USB mouse but not a USB keyboard. There are provisions in the BIOS (Award) for USB mouse and keyboard use. Have you tried to start the machine with a PS/2 mouse and keyboard to se if the BIOS on your machine is set correctly?

by shanghai sam

Thank you for responding rwayne1, one of the first things I checked was the bios to make sure that I had USB keyboard enabled, it was. I would love to hear any other suggestions though.

by donmars

I do not think the other answers read your question carefully. You did say you have a CORDLESS usb keyboard? Is this keyboard IR (infrared) type or RF (radio frequency) You should make sure the keyboard is able to easily send and recieve signals to the base station part that plugs into your Computer box. If the cordless setup is RF type beware of emissions from your monitor scrambling the signals. Move them further from the monitor. If the unit is IR make sure there is a good line of sight pathbetween the units. Also a TV remote controller may conceivably cause a signal sramble condition for the IR receiver. Of course you checked the connections for fidelity? You did not say what type of operating system you were running. Win 98 SE has problems with USB devices if the following hardware components are installed on the computer:
An AMD processor 350 MHz or faster
A VIA Technologies USB controller.

Go to this site for the solution:

http://support.microsoft.com/directory/article.asp?ID=KB;EN-US;Q240075

by jrjacques

first things first. in your manual you should have instructions to train/link the devices using a button on each remote device (kbrd/mouse). If this has been done successfully then check the bios settings that USB support for legacy devices is installed or your kbrd/mouse will not be found by the motherboard. If these do not work for you than check the manufacturers site for support as you may have a bad kbrd.

by rwayne

I am going to take another stab at this. There are three dirvers that should be installed in the system32 directory;
i8042prt.sys , itchflr.sys & kbdclass.sys if you are using the Logitech wireless keyboard. (I am assuming that you are running a Windows OS). There have been reports of USB devices not being detected at boot time. The problem is resolved after the appropriate drivers are loaded in the kernal stage of start-up. Does the device manager show anything at the keyboard or mouse position? There should also be a listing for Human Interface Devices. If this is not the case, remove all Logitech drivers and see if the OS tries to re-install them. As someone else posted, Win98 is notorious for not detecting USB devices; on of the many reasons that I do not run Win98.

This discussion is closed to new replies.