Discussion Locked

Lack of power to cpu fan

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Opening up the box, I noticed that the cpu fan was not working. I opened a new cpu fan and replaced what I thought was the bad one. Once replaced, the new one did not work either. This is the second box I have encountered that had this problem. Ithen tried the cpu fans in another box and they worked.

Any ideas? The motherboard in this box is new so I don't know why things would be shorting out so soon. Where should I start to find out why I do not have any power to the cpu fan?

Thanks in advance for any ideas.

Kim Rainbow

11 replies

by dmiles

You can start with the power cables to see if they are attached properly,then check the power supply to make sure that you are getting power to the mother board.The cable taht is supplying the power seems to your problem and it not that expensive toreplace

by krainbow

I am getting proper power to everything else. The pc works properly with the exception of power to the CPU fan.

by aronya1

Sounds like a simple short somewhere in that power link. There may not be any way to fix it other than to replace the motherboard. You said the board is new. Can you take it back to the vendor for testing? I would do that first if possible. Arethe boards in the boxes that work the same as the problem board(s)? If not, maybe there is some kind of bizarre incompatiblity with the fans you are using (OK, this one is a longshot). If the board ARE different, maybe the problem boards are just an inferior product. Hope this helps.

by macgyver.hicks

Hi krainbow,
Here's something else to check on. My BIOS has an option to control the CPU fan. You might want to check to see of it does and if it is set to activate at a certain temperature. It's easy to check and will cost you only a little time. I wish you well
with this.

by geroxx

What motherboard are you using?

Are you connecting to the correct fan connection on the motherboard?

I would have to agree with the previous posting about checking out what is in you BIOS. I have a motherboard that can control when the fan comes on via a temp probe. There is also an option to have it shut down the system if the fan stops or the temp goes up to high. Its different for different MB's. Its hard to know what you need to do with the information provided.

If you are connected correctly and you have the BIOS set properly then I would have to say you got a bad MB. Its been known to happen.

Gary

by rawright

I don't know where the temperature sensor is located on your system, but if it is part of the heatsink assembly rather than integrated into the MB, it may be defective or have a loose connection to the motherboard. It's possible, too, that an enabling jumper clip may have been loosened in shipping or installation. Try removing and reinstalling any motherboard jumpers (NOT the CMOS reset jumper, though) that may be related to the fan.

This discussion is closed to new replies.