Discussion Locked

Loud Noise only on Cold Start Up

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Loud groan lasting 30sec after cold bootup.
CPU fan and graphics fan seem OK, since
groaning remains when these fans are unplugged.
However, if the Power Fan Warning Alarm
is selected as enabled, then ab alarm is sounded until the warning in BIOS PC Health is
disabled. The fans on the ALlied power
supply are not binding.
If it is the Power supply,how can I
troubleshoot it?
thanks,
lucy

6 replies

by thechas

The groan is not from a fan binding, but from a fan with worn out bearings.

What happens is the bearings get loose, and the fan blades then either rub against the fan housing, or the grill.

Aside from the power supply fans, a worn bearing on a drive can make the same noise.

Also, check your video card for a fan.

Chas

by thechas

Got your message.

My first suspect would be power supply fans followed by any of your drives.

We run a LOT of PCs 24/7. When they are turned off for any reason, cooling fans and drive motors tend to groan at startup.

The PCs have been running so long that the bearings are worn and it takes a few minutes for the motors to get up to speed and settle back into their "normal" positions.

I just replaced the power supply fans on my PC for the same symptom.

Keep in mind that the bearings will continue to wear and at some point they will fail.

If it is a drive, back up your data and replace the drive as soon as you can.

If it is the power supply fan, it may be cheaper and easier to just replace the whole power supply.

Chas

by thechas

One way to check the power supply fan is to gently tap on the power supply near the fan and see if the noise changes.

Chas

by willcomp

Give Chas the points on this one, but a quick tip to pin down culprit.

Disconnect power cables from hard disks and optical drives (optical drives can also be quite noisy at times). Boot PC. If noise is present, it's power supply, cpu fan, GPU fan, or chipset fan. You can momentarily stop most CPU, GPU, and chipset fans by pressing on fan center hub. I suspect you get the picture.

If noise isn't present with drives disconnected, sequence back until you identify culprit.

Probably is power supply fan. They can be replaced fairly easily if you're handy. May have to splice fan power wires.

If older, cheap, under powered PSU, may want to replace (if standard ATX).

Dalton

by chris910

The previous answers will likly be the solution to your problem but here is one more thing to try to extend the life of your fans. (if this is a business or mission critical machine, replace the fan now. Save yourself the trouble of having it not work at an inconvinient time)

Often times the collection of lint and dust will cause the fan to be out of ballance wich is a problem untill the fan comes fully up to speed and the berrings seat into the wear groves that have been created on the races. Clean the fan blades using compressed air. NOTE: DO NOT ALLOW THE BLADES TO SPIN WHILE YOU ARE CLEANING THEM. compressed air will spin the fan to fast, damaging the bearings further. I use a paperclip or pencil to stop the blades from turning.

This discussion is closed to new replies.