Discussion Locked
0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Hoq can you we prevent a modem from misinterpreting line noise as a carrier drop?
5 replies
by lwt
You could try adding a line to your Modem Properties in Control Panel>Modems>General>Properties>Connection>Advanced>Extra Settings such as S10=20. This will adjust the S register for carrier-loss disconnect time. If you still have problems, try increasing this setting to 30 or 40 or even greater until the modem stops disconnecting when you are online. However, your bps might be less than usual.
by excel_gid
Poster rated this answer
by istmaj
In addition to the first answer, It depends on the type of modem. (USR, Supra, etc)A couple good sites that I use a lot are: www.modemhelp.net
www.modemhelp.org
or if you have a generic type modem and not sure of the chipset try http://webusers.warwick.net/~u1001562 This site will help you figure out what init string will help.
Good luck!
by excel_gid
Poster rated this answer
by excel_gid
This question was closed by the author
This discussion is closed to new replies.
Trending Desktop posts
Sort by Trending
Question
Floppy drive wont work on my 486
0 helpful
1 reply
Discussion
How to make light speed agent go away
0 helpful
4 replies
0 helpful
1 reply
Discussion Locked
Ryzen 7 7700
0 helpful
2 replies
Question Locked
Issue fully resetting my PC
0 helpful
4 replies