Discussion Locked

modem speed question

0 helpful
14 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I am having a modem speed issue. I am unable to connect at speeds any higher the 24400. I have a good modem, phones lines are good, and yes the isp has tons of 56 modems with the same protocol. I am running win98se and have office 2000 installed which I was told might be causing the problem. Any suggestions?

14 replies

by calves

Look at the properties of your modem and where it tells the maximum connection speed, usually for the new modem 115.000 or 224.000 reduce it to 57.600 and try it again.

Good luck!

by sbybee

Also download a program called "ISPEED". It is a program that will make the neccesary registry changes, it will change the MAXMTU, NETRANS ect.. so it will run at full bore as to say.

http://www.hms.com

Steve

by mphoffar

Your phone line may be good as far as what you expect and what the phone company requires and a minimum standard, but as far as your modem is concerned, the line isn't so great. Usually when I see speeds below 26400, it's because the line has been split. Basically two or three phone connections sharing the one one line that goes to the pedistal. When this happens you lose a one band that is used for higher speed connections, and you lose line voltage which is necessary for anything higher then 19200 to work.

Best way for you to check this would be to go to a friends house who is getting higher speeds and connect there to see what kind of connections you get there.

Mark

by mckaytech

I can't imagine how Win98SE/Office2000 have anything to do with modem speed unless you have a dog-slow computer that is just plain overloaded.
US Robotics (now 3Com) has a test line you can dial to see if your phone line is capable of supporting 56k. One of the aspects of the v.90 standard that doesn't get much press is that there can only be one analog/digital translation between you and the other end. Many times, when the phone company runs out of trunk capacity going to a particular neighborhood, they will install a multiplexer that piggybacks more calls on the existing trunk and the extra A/D translation involved brings v.90 to a halt.

I'm inclined to think the problem is the phone line and I think it would be interesting to knowif your computer will connect at higher speeds from another location.

paul

by jdhouck

Take heed of the good answers above, each one has very useful info. We have solved the same issue by downloading newer drivers for your specific modem. After installing new drivers, try it again, if no improvement move on to another location (friend's house) to verify your phone line can handle v.90. You have probably already done this, but, verify you have more than 100 mb free on your harddrive and RAM should be 32 MB (or more) with WIN98SE. After you get your modem working better, move on to the suggestion about the software for streamlining the registry variables. Good Luck,
JH

by austinlim

Hi, you can try using some software to detect any problem and optimise it.
(Modem Wizard and Terminal Overdrive) You can search it on shareware.com, download.com, winfiles.com etc

Good Luck

This discussion is closed to new replies.