Discussion Locked

Modifying Access Database

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a simple two table Access 2002 database. How do I add new features (tables/forms/quieries) that I have developed on a copy to the original database (the data in the original database has grown whilst I have been developing the new features)?
Many thanks.
Tony Boyd

4 replies

by skipperusn

When you copied the Database did you select it as the master? - Did you use the brief cases?

Otherwise you may have loads of manual work ... unload the old database to a flat file - then load it into the new database... and verify the links...

Ugly -

by skipperusn

Hum - I always mark one the master and the other the Replica - so that when the design is changed I can just update the replica...

Not - sure how to hand it when not done that way ... Sorry - hope someone else can answer your problem ... Don't want to point you in the wrong direction..

Good Luck..

by seventony

If i start again and do the master/replica thing, you seem to be suggesting it would be much more straight forward? correct?
thanks

Tony

This discussion is closed to new replies.