Question Locked

Monitor Loses Signal Periodically

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I'm using a Dell Dimension 2400 Computer with an HPf1905 monitor.
For the last 3 or 4 days I have been having my screen go blank after an hour or two of use. The monitor turns off. If I do nothing other than turn it on at the switch on the monitor, I get a message on the screen that says no signal is being received. The computer operating lights are still on.
I removed and replaced the signal cable yesterday, but it seems to have little effect. If I shut off the computer and immediately restart it, it will run normally for another hour or so.

Any suggestions?

3 replies

by oh smeg

You will get much better results by fitting a Dedicated Video Card and you'll love the improved performance as well.

But before doing anything else you need to check the Hardware function so get yourself a copy of the Ultimate Boot CD available fro free download here

http://tinyurl.com/3jnpy

Make up your own copy of this CD and then insert it into the Optical Drive and if necessary change the Boot Order to Optical Drive then HDD in BIOS and boot off this CD.

Run a full suite of Diagnostic Tests to see if there are any major hardware issues and if there is nothing seriously wrong with the unit fit a new Video Card with at least 256 MEG of Video RAM.

You will need to change the Video Lead to the new card and then run off the new Video Card. Of course when you open the case clean it out and make sure that you get all of the dust out of the CPU's Heat sink with Canned Air. When you are blowing out the Heat sink make sure to prevent any fans from spinning as they will generate power and may damage the M'Board or other Electronics.

Also follow standard Static Control Procedures to prevent giving the insides of the computer a hit with a Static Discharge which can destroy the computer.

Col

This discussion is closed to new replies.