Question Locked

Monitor Out of Range

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi, I am having a problem with my monitor. In the morning it was working fine and all but when I switched it on at night, the monitor shows out of range. I could not do anything about it except to go into F1, which shows me a lot of information. When I let the computer run normally, it loads fine, it even shows Windows XP loading. But after that, everything just goes wrong. I could not see the part where I am suppose to choose the user nor enter the control panel at all. Is there anyway I can fix this problem? Or is it possible for me to do some adjustments or changes at the beginning of F1 in order for the monitor to work properly?

I really appreciate any help you are able to offer. If you require more information, please let me know.

2 replies

by oh smeg

But by the sounds of your description the Monitor Resolution or Refresh Rates have been pushed above the ability of the monitor to handle. You can try with another monitor preferably a fairly new CRT Type as these are not limited by any upper limits and you can then readjust the Screen Resolution & Refresh Rates down so that the monitor can display them though before attempting anything else I would suggest that you try this monitor on a different computer just to make sure that it's actually working properly and hasn't failed or developed some other fault first.

If you can not get another CRT Monitor that will produce a display when Window Opens and all the drivers are loaded you can start the system in Safe Mode and remove the Video Driver so that the next time you boot the system you will have the default Windows Video Driver and will need to apply the Video Driver again so you get a decent picture that you can view easily.

Col

This discussion is closed to new replies.