Discussion Locked
0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
using windows 98 os and a plug n play monitor can you force/command to a particular resolution (800x600). the video controller is integrated into the motherboard. the resolution is at 640x480 and I can not get it to change!!!!
3 replies
by thechas
Sounds like you either need to update the video driver, or allocate more memory to the video card.
Early on-board video systems used low end graphics chips and were often limited to 2 or 4 MB of video RAM.
If you do not have at least 8MB of video RAM, your resolution and color depth will be limited.
Check BIOS settings, and see how much RAM you can dedicate to the video.
Then, verify the specific graphics processor, and download the latest driver from the chip manufacture.
Chas
by boreg30
Poster rated this answer.
by boreg30
This question was closed by the author
This discussion is closed to new replies.
Trending Desktop posts
Sort by Trending
Question
Floppy drive wont work on my 486
0 helpful
1 reply
Discussion
How to make light speed agent go away
0 helpful
4 replies
0 helpful
1 reply
Discussion Locked
Ryzen 7 7700
0 helpful
2 replies
Question Locked
Issue fully resetting my PC
0 helpful
4 replies