9 replies
by thechas
Not enough information to give you a definitive answer.
First, we need to know the exact model of the motherboard, video card and CPU.
The first thing for you to check is does the motherboard support the AGP mode of the video card, and the front side bus speed of the CPU.
Next, did you just build up this system?
If so, check the motherboard for the clear CMOS jumper.
Often, motherboards are shipped with the clear CMOS jumper set to clear.
It needs to be set to normal for your PC to boot up.
Chas
by hal 9000
As Chas has quite rightly said you have provided no where enough information.
Does the CPU fan keep spinning when you turn on?
If it does you will have to check the type of AGP card against the M'Board supported cards. If it doesn't the power isn't being turned on so you'll have to check the connectors on the M'Board to the front of the case. Just a word of warning here I've seen a few cases recently with some badly molded buttons on the front so it could very easily be the reset button being in the ON position that is stopping the unit giving off a display. Similarly the AGP card might not be properly seated in the AGP slot. and again you will be getting no signal.
The possibilities are almost endless and without the make and Model of the M'Board and Video card it will be almost impossible to offer any more assistance.
If you would like to post back these details we will most likely be able to advise you but without these it is all just guess work.
Col
by jkaras
by dji22
Poster rated this answer.
by sgt_shultz
by dji22
Poster rated this answer.
by hatman
by dji22
Poster rated this answer.
by dji22
This discussion is closed to new replies.
Trending Desktop posts
Sort by Trending