Discussion Locked

motherboard or Processor??

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I would like to fire a question about a SIS 620 PGA 370 M.B., when i put up the power the output is totally dead but the P.S. is working fine i suspect the BIOS I replace it with the same model but no result.. i check the video card, the built in Video card the jumper settings,the setup speed for the Processor.. is all there and properly setup.. then i pull out the processor (celeron)to check wat will be the error.. the same output was given to me.. a DeadOutput! and no Beep from the Speaker its like the processor is not working at all? or the motherboard got the problem?? and i will not risk to put the processor to other boards coz it may also damage the board and vice versa with the motherboard.

p.s. i check the current/voltage and its fine, the CPU Fan works fine too..
thank u very much!! (I hope u can help guys! :) )

5 replies

by maxwell edison

Greetings,

It's extremely rare for a processor to fail. And in most cases, when they do, it's because a frozen CPU fan went unnoticed (or ignored) and the processor literally burned up. Since you verified that the CPU fan does - and did - work, the most likely culprit is your motherboard. And to address another one of your concerns, I've never seen a case of a bad processor damaging a good motherboard or vice versa.

Good luck.

Max

by madcateast

You say that the voltage at the power supply is good, were? I just recently had a problem were a system would not start. There was voltage at the power switch but it would not fire. The problem was in the PS. Hitting the switch would not jump the relay in side the PS to fire up the system. If you have an old or small PS around try it out. If it?s too small it will work for the testing but don?t run the system on it.

This discussion is closed to new replies.