13 replies
by dmiles
Boot computer,when the startup screen appears,press designated key to enter Setup,locate the HDD configuration and see if the setting listed as Auto and LBA
You can manual set the hard drive configuration or use the hard ddrive auto detect in the right pane,when finished
Exit and Save
by super_it_mom
Poster rated this answer.
by cwdunn
by super_it_mom
Poster rated this answer.
by sgt_shultz
by super_it_mom
Poster rated this answer.
by jkaras
by super_it_mom
Poster rated this answer.
by donmars
by super_it_mom
Poster rated this answer.
by ginese11
You may want to check you're IDE controller and make sure it is enabled. Some of these suggestions may seem basic, but never over look the basic first.
When you upgraded you're BIOS the drivers on you're drive were the old ones. If you have a CD Rom, run it in you're primary and Change you're settings to see if you're system recongnizes the CDRom, this will narrow down where the source of the problem.
You may set you're BIOS to Default setting and boot it up. Hope these few suggestions help.
Mrfix_it
by super_it_mom
Poster rated this answer.
by super_it_mom
This discussion is closed to new replies.
Trending Desktop posts
Sort by Trending