Question Locked
0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Hi, I'm trying to replace the HDD's on some elderly IBM compatible equipment that I run with flash disks. It has to run MS-DOS, and be compatible with BIOS dating from 1998. A step by step guide would be very useful, I am only moderately technical. I'm planning to use 256Mb flash disks. Can I just get an adapter to fit the flash disk to the HDD ribbon cable, then format it and load MS-DOS from floppies. Will the BIOS recognise the flash disk as a HDD? Any help would be appreciated.
2 replies
by abaxter Accepted solution
Clarifications
by rob miners Accepted solution
It would be easier to connect the New Drives to a newer PC and install DOS from there. You can then move the Hard Drives into the Older PC's when you have everything installed.
You didn't mention whether they are Notebooks or Std PC's. You can use a Notebook IDE Hard Drive Adaptor if the Drives are 2.5", if they are regular Drives just connect them to IDE 1.
A Flash Disk can only be connected through a USB Port.
This discussion is closed to new replies.
Trending Desktop posts
Sort by Trending
Question
Floppy drive wont work on my 486
0 helpful
1 reply
Discussion
How to make light speed agent go away
0 helpful
4 replies
0 helpful
1 reply
Discussion Locked
Ryzen 7 7700
0 helpful
2 replies
Question Locked
Issue fully resetting my PC
0 helpful
4 replies