9 replies
by dmiles
The constant beeping is most likely indicating a memory problem that could be caused by memory that is incompatible with the machine.
Make sure that you have the same memory upgrade to match memory already in system and that memory is not mismatched using 133 ecc compared to non ecc.Check memory carefully to insure that it matches
Check the slots and make sure that the memory is seated properly in the slots.
Check the motherboard manual to see how much memory is supported.
One concern is that the BIOS detecting the memory and configuration is set properly.
Reinstall the faster memory in Bank 0,and work from there,by installing one stick at a time.
by pfedynich2
by raffi_
As you have already removed the new NIC and RAM I would suggest that perhaps you may have dislodged something during the install.
It takes only a couple of things to completely diasable a boot process. Check the following:
- CPU firmly seated in the slot?
- RAM firmly seated?
- video card firmly seated?
- All IDE/flooppy cables secure?
If this is so then try this:
- remove all but 1 stick of ram
- Disconnect ALL cables from the motherboard
- remove ALL cards except video
Stillbeeping? Move the RAM to a differnet slot. Try a PCI video card if available.
Still beeping? Chances are your motherboard is toast (sorry).
If you can now get video signal then all is not lost. Try adding back the devices one by one until theboot fails and you have found the culprit.
Regaqrds
Raffi_
by pfedynich2
by burns
I agree with raffi, in that you probably dislodged something. Those beeps are called "post codes" and mean that something critical is wrong with your machine such as a nonfunctioning (or just dislodged) cpu, memory, or video card.
What you should do is write down exactly how many and how long the beeps are, ie long, short, short. Then look on your motherboard for a pretty small chip rectagular with a silver sticker on it (the bios chip usually located around the edges). Note who the manufacturer is of this chip (award, phoenix, ami). Then you need to go to their website and look up "post code" in the support section. When you look this up, it will tell you exactly what is not functioning. Then try reseating or replacing that component.
by pfedynich2
by danpiers
by pfedynich2
by pfedynich2
This discussion is closed to new replies.
Trending Desktop posts
Sort by Trending