Question Locked

n00b ram install

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Hey guyz im not too savvy when it comes to computers but i recently purchased a 512mb ddr stick of ram from circuit city installed it and my computer wont boot i think i got the sequence right afew times after i got the sequence right it would come up with a hardware changes menue and asked me how i wanted to boot my computer was i supposta boot it in safe mode? Now it wont even come up with that option when i boot my computer with the ram stick in any help would be appreciated.

3 replies

by gary56789

uninstalling the new chip first and make sure that everything boots ok. If ok, make certain you have the correct type of chip, and then reinstall. Make sure both sides clip-lock into place (some types take a lot of force). Then reboot.

If it works ok without the new chip but not with the new chip, that is probably the culprit. Hopefully you purchased from a reputable firm and can exchange the product.

by oh smeg

If it now works properly you have a Stick of RAM that isn't compatible with the M'Board or you have a faulty Stick of RAM.

To test the latter try removing the original RAM and just boot off the new RAM and see if it now works. If it does you have an incompatibility between the different RAM which will most likely be a Timing issue. So you will need some different Spec RAM to work properly on this computer.

Just to double check look here

http://tinyurl.com/2r5uw6

Enter the details in the middle option and make sure that you have brought the correct RAM.

Col

This discussion is closed to new replies.