First, since support has fubared the settings press and hold the reset button in for 15 seconds. Release, Wait for the lights to return to steady.
Write down your current settings (on your computer, cmd-ipconfig /all).
IP Address
Subnet Mask
Gateway
DNS - Primary
DNS - Secondary
Disconnect the lan cable to your computer.
Connect a lan cable to the second Belkins Lan port.
Open a browser type in this address 192.168.2.1
Login (there should be no password now that you have reset the router).
Go to the WAN setup tab, choose Static.
Enter an IP address consistant with your current network - likely 192.168.2.254. Remeber this address it is your routers new IP (unless reset again).
enter the submask 255.255.255.000?
enter the gateway 192.168.2.1
enter the DNS 192.168.2.1 & one from the ISPs.
Press the Apply settings button (you will likely be disconnected, enter the new IP address in your browser.
Go to the Lan Tab.
Turn off DHCP.
Give the router the same address that you named it before. i.e. 192.168.2.254
same mask.
Look near the bottom of the page for domain name. name this the same as your workgroup name (may be optional, but it has been awhile since I set one up).
Lastly set a password on the router, store this with the IP address if you are not concerned with physical access.
Unplug the Lan connection. Connect a cable from a port on Router1 to the WAN port on the newly setup Router2.
Don't forget the cable between one of the routers and your desktop.
All done.