Discussion Locked

No Display on Screen

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Respected Fellows!
Whenever I turn my computer on, everything seems to be right, but I cant view anything on screen, Even monitor is working well.., and for some some tine its light remain green, but then it become Brown!
and also I can't here Booting TONE of my system!
Please help me in this reagrd!
Thanx

11 replies

by pcjockey2000

I have seen this in two situations. Bad memory and internal conflicts of hardware.
Try replacing your system memory with known-good memory if you have it first. If that doesn't work, take out all of your PCI and ISA cards except the Video. Unplug any USB cables from the PC if you have them. Try to boot up. If it does, replace the cards one by one until you find the one that locks it up. If it still doesn't boot up even with all the cards gone and good memory, try a new video card. If there is still nothing you probably have a bad Mother Board.

Hope this helps.

by csmith

If this happened all of a sudden, lightning has hit the telephone lines somewhere, or you have had a severe power surge. To test remove everything from the motherboard, and install only "known good" parts. We keep old "known good" ISA video cards, old simms (4Meg), and old floppy drives for this test. Install the "known good" video card, ram and floppy. Try to boot on floppy. If no boot. Check power supply. If the voltages are OK and stable, email me, there is not enough space allowed here.
Regards, Chris

by berserker

It's probably your PCI/AGP display card that is not seated properly into the slot. Take out the display card and reseat it into the slot again. Check that the pin connecter is not broken or bent for the monitor.

by bean baggins

The primary symptom here is the loss of the POST tone. Several questions first then. Do your power light and hard drive activity light on the case light up? Can you hear the hard disk spin up? Do the keyboard lights flash briefly? Does your floppy disk drive light come on for a few moments. If the answer to all of these is no, it is possible that you have a failed power supply, CPU or system board. If the answer to all is yes, then the problem is likely (as suggested in the last response)the video card. Disconnect the monitor cable then power on. If you hear a beep sequence, usually one long - three short, this will indicate that POST recognizes that a monitor is not connected to the video card. Check the pins on the monitor cable, some may be missing, this is normal. Firmly reseat the monitor cable and power on again. If you have access to another monitor, try it. If the problem persists, remove the case and reseat the video card. if this doesn't work try another video card. Good luck.

by nsceml

I had the very same thing happen exactly as you described when I upgraded my BX board from a PII 300 to a Celeron 633 and for a time, the celeron wasn't being recognised, I finally fixed the problem, er, it fixed itself, but it leads me to think that your CPU is not being recognised either, and the only reason for that in your situation s that it may have bit the big one. Try another CPU.

This discussion is closed to new replies.