Discussion Locked

No "E" drive icon after installing CDRW.

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
After installing a new cd-rw and properly defining it in "device manager" I still get only an icon for my "D" drive in "My Computer". However everything works correctly(DVD and CD-RW).

5 replies

by sixfourtykilo

If you are NOT getting your "E:" drive after installing your CDRW then everything is NOT working correctly is it? Check several things: first check to make sure that your jumper settings on your drives are correct. CD Writers generally want to bethe master and should be. If you have it installed on the same IDE channel as your DVD, then check to make sure that one has been jumped to MASTER and one to SLAVE (do not use CS). Also check your CONFIG.SYS file for a LASTDRIVE= line. It really shouldn't be there, using Windows, and if it is, it is generally set to Z (LASTDRIVE=Z). Check your the properties of your device in device manager and make sure that somehow, the assign a drive letter isn't set to conflict or set to some other letter. If all else fails, try removing the DVD and see if you can get the CDRW to work at ALL. If it does, either your jumpers are set incorrectly or your cable is bad.

Good Luck!
640k

by stevcrawf

I tried ALL different configs and defined it correctly in "Device Manager" as "E" and config.sys is ok too. Another tech friend suggested clearing out CMOS bt shorting the pins, but I use that as a last resort . Thanks.

by jhinrichs

After installing it to the system as E and your rebooted for good measure. If you go to a command prompt and go to the e drive, does it let you? Can you see the contents of the drive? Do you have tweakui or any other regristry tools that could hide any drive leteters. This would only be the case if you can access the drive from a command prompt. By chance do you have any DOS cdrom drivers loading during boot? If you in Device Manager switch the drive lettes for your DVD and CDR does the CDR show up and the DVD go missing? How many partions do you have on your hard drive and do you have this computer on the network were drive letters could be an issue?

This discussion is closed to new replies.