Discussion Locked

no picture

0 helpful
19 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I JUST UPDATED MY COMPUTER, NEW MEMORY,NEW HARD DRIVE, NEW CD-W. THE PROBLEM IS THAT ONCE I CONNECTED MY MACHINE UP WINDOW 98 BOOT UP O.K. BUT THEN AFTER THE BIO INFO- I GET A BLACK SCREEN. HELP!!

19 replies

by jjbirds

have you any dig software that you can run from start up check that the memory is running fine could be the cause.

by jjbirds

check your harddrive is connected right then the primary ide channel is selected and your bios have found your new harddrive

by dmiles

Sounds like the MBR is corrupt ot the startup floppy has a virus
You will need a clean boot disk
Cold boot to command prompt and type FDISK /MBR
Reboot and at the command prompt type SYS /C
it woould be helpful if you had a anti virus ERD to boot from in case that it is a virus

by grump

Ok, lets start with the basic. Memory- Windows needs to load HIMEM.SYS and if your new memory is the problem the you will possibly be sitting there a long time waiting and waiting.
Make sure that the HDD is Jumpered correctly.. and also the CD-W is jumpered correctly.. if you have both HD and CD on the primary and both are jumperd master you will get a blank screen..

Try un pluggin HD and CD-W leaving only these items. Power connected to the Mother board, keyboard connected , video controller and monitor, and the "NEW MEMORY", along with the diskette drive A: connected. Insert you 98 boot diskette (you don't have one,, for shame on you), if you system starts booting from the A: drive and gives you a command prompt you next step would be to shut of the computer and add the HDD and cable to the configuration. Power on and boot up to the A: prompt and see if you can access the C: drive. Next shut off the computer and add the CD-W and power on the computer and boot again form the A: drive..

by william jay

First some questions in response to this question and answers ...

1. What is a psu?
2. Did you run the BIOS setup program and set all the drives to 'auto' detect, and are they in fact detected properly?
3. Why write in ALL CAPS?
4. How much previous experience did the installer person have?
5. What is the difference between an update and an upgrade?
6. Do you like this style of problem solving?
7. Will you please post more info about this problem, and keep us posted as to what the problem actually turns out to be?

by j.wilson11

I can't tell from your question...

Did you install Win98 on the new hard drive?

If you haven't gotten that far, your IDE cable from the hard drive to the motherboard could be backwards, red or blue stripe should be on the side of the power connection on the hard drive and towards the '1' printed on the mother board connector.

Then re-install Win98.

I Bios POST recognizes the correct amount of memory on the first screen, memory should not be the problem.

one more thought, if connections are all correct and software is installed correctly, can you boot into safe mode (press f8 at 'windows starting)? Could be the resolution is too high.

Hope this helps,
Wes

by nicholasp

we need more info...
You say WIN 98 boots up. Does this mean you see the splash screen? If so, does it boot up in safe mode?

You might have a simple problem of having the wrong video driver or resolution.

by colwello

It is definitley a vga or resolution problem. When rebooting hold down CTRL and start your computer in safe mode. Go to the start menu, settings, control panel, systems, and once you are in your device manager remove your display driver. Reboot and let your pc re-install the vga driver. Reset your resolution, but not to high because this sometimes messes up your refresher. Reboot to apply you resolution setting.

This discussion is closed to new replies.