Discussion Locked
0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
A friend of mine owns a 1994 American Megabyte PC. When it starts to boot up, the error appears "NO ROM BASIC - SYSTEM HALTED". I cannot access the hard drive to view the stored contents. I cannot save any changes in set-up. Any ideas on how I can repair this?
3 replies
by syscokid
Was it working ok up till now? Did you install a new hard drive in it?
The most common cause is the lack of an active partition on the disk. You would need to boot from a floppy and run fdisk to see if there is an active partition. If there isn't, you'll have to set the primary partition to active.
If there is an active partition already, then the motherboard and/or BIOS may have failed.
by melissa
Poster rated this answer
by melissa
This question was closed by the author
This discussion is closed to new replies.
Trending Desktop posts
Sort by Trending
Question
Floppy drive wont work on my 486
0 helpful
1 reply
Discussion
How to make light speed agent go away
0 helpful
4 replies
0 helpful
1 reply
Discussion Locked
Ryzen 7 7700
0 helpful
2 replies
Question Locked
Issue fully resetting my PC
0 helpful
4 replies