Discussion Locked

No Video Displayed

0 helpful
12 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Would appreciate help in determining why I have no video displayed on my monitor whatsoever even during boot up. It is definitely a PC problem rather than monitor.
I think it may have something to do with the Bios as this seemed to happen after I loaded the 'Load Optimised Defaults' in set up.
System is Win98se based with a celeron based cpu. Need big help here people.

Thankyou.

12 replies

by campbell

What i would do is flash the bios. you can do it two ways. 1)remove the battery for about 10 minutes 2)use the jumpers on the mother board, you will need to reset the time and date in the bios after you are done. this will reset it to the factory defaults. hope this helps

by krunch

If flashing the bios doesn't work you can try a couple of other things. Elimination works best in cases such as this. First try the monitor in another machine, if the monitor works in another system then it's fine. Next, you can either unplug your video card and try it in another machine or you can try to hoark a video card from a spare p.c. and try that in your system. Getting the drivers down from the network can be a hassle but if it works you could alway buy another video card - video cards are pretty cheap right now.

HTH! Good luck.

by krunch

Oops, I forgot your mentioned the monitor was already okay. Still though, if the bios flash doesn't work, I'd give that video card a pull and try another one.

by estebandelatorre

Big help is not allways available!!!
If you can get inside BIOS Cmos setup select the restore default settings or...

Locate the jumper in the motherboard to clean the bios setup, move the jumper to the reset position for 30 seconds and bios wil be reseted to default values.

Hope it helps.

by paul d. masley

Try this simple fix. I did and it worked. Completely shut down the system. Unplug the power cord. Ground yourself to the case and remove the video card. Also, remove all memory strips and unplug the hard drive. Remove the CMOS battery. Make sure that you leave the floppy and cd plugged in. This stops a power surge through your power supply. Let box set for about five minutes, then replace the CMOS battery.

Replace the power cord and boot the box. You should hear all kinds of beep errors. Shut down the box, remove power cord and ground yourself, then install one memory strip and the video card/monitor. Replace the power cord and using a boot disk, reboot the box.

For some reason, doing it this way, forces the bios to deal with the card without the benefit of the harddrive (and drivers). It also sets the bios to minimum defaults. If you get video, shut down and reinstall any additional memory strips that you have, then reboot with the boot disk. If all goes well, then reconnect the harddrive.

I had this problem with a NVidia MX400 card. This way solved the problem.

Paul.

by halstead55

Once again my answer is to assess the basics first as with previous post check monitor and video card with another PC. If both appear to work fine then check the monitor cable itself check no pins are bent or broken and check for a lose mount on the video card. Furthermore do u get any beeps on boot up, if so check your motherboard handbook for an explination as to the fault.

This discussion is closed to new replies.