Discussion Locked

not detect hd

0 helpful
13 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

i want to add new hd in my computer.i've already install win98 into that hd (using another pc).when i try it into my pc,it won't detect the hd.(when i enter to cmos,it hang(got to restart again)).
it's say pri master hd errors,press f1 to resume.then i follow the instruction,and it's ask me to insert the boot disk.
then the screen shows "windows 98 has detect that drive c does not contain a valid FAT or FAT32. There are several posible causes.".....
But when i try it with another pc,there's no problem.My motherbrd is celeron 300mhz.
Can anybody tell me why and how to solve my problem.

13 replies

by chaosad

Have you set the Standard CMOS settings to Auto and then try to do a hard drive detection? or is this the first hard drive to ever touch this mother board?

by key

What is the storage size (?M), speed (DMA-66/100)?
Jumper setting is correct?

by diskaus

Try checking your jumper settings find out the make and model number of the drive as well as the capacity if the jumpersettings are not written on the drive its self you can find them through the Manufacturers Website.If then it wont read the HDD itcould also be that because the drive has had the O/S loaded onto it through another system .It may not recognise the HDD because it was not loaded through your bios . You may need to load windows through your bios.

Good Luck :-)

by mcarrara

Before we get to your HD detection problem there is another issue. Windows installations are hardware dependent. If you installed Win98 on another PC and then but the HD in yur machine you may have some problems.

Now for the HD. Is it possibleyour motherboard uses cable select to determine which drive to boot from? If it does try switching the position on the cable. If not; Make sure the jumpers on the HD are set for master. Make sure you are connected to IDE1 not IDE2.

by @lberto

Did you let the BIOS auto detect your new hard disk?
Let's assume that you say "YES", there are some posibilities around here.
The first one is that the other pc where your formated and installed windows 98 didn't detect the hard disk settings as this other machine did.
Suggestions, go to the other pc, check the settings it takes when you install this new hard disk and manually set it up into this other pc.
Let it boot and see if it detects the hard disk.
Please e-mail me backup if it doesn't work, and give me some more details, like Mainboard brand name, hard disk specifications, etc.
Good luck,
@lberto

by tech/admin

If you installed in another machine and this drive was a slave, or 2nd drive-- you need to check your jumper settings. If it is set to slave when you try to start the machine will not find the active partition because it will be looking for the master. Also installing 98 somewhere else has set all drivers and settings custom to the pc you installed 98 on. Once you get on this drive Go directly to DOS Mode and reinstall- resetup windows on this machine. You will need the same OEM Registration number you used for the first setup to continue the second.

This discussion is closed to new replies.